Fanuc Wn57 Override - Function Is Active __full__

If the machine was recently accessed remotely via FANUC LADDER-III software, the override might have been triggered from the external PC. Summary Table: WN57 Message Details Description Message Type PMC Status/Warning (WN) Standard Address Typically controlled by K906.0 Criticality Low (Warning), but unsafe for production Required Action Disable Override Function in PMC Settings

Because WN57 is an "active" status rather than a failure, it can usually be resolved by toggling the function off through the CNC’s internal settings or by modifying a specific Keep Relay ( -address). Method 1: Using the PMC Parameter Screen Navigate to the on your FANUC controller. Select [PMC SET] or [PMC PARAM] . Look for the Setting or Override sub-menu.

Debugging and testing the sequence program during machine setup or intensive maintenance. fanuc wn57 override function is active

FANUC documentation explicitly states that this function should be disabled before shipment or returning the machine to regular production. Leaving it active can lead to unexpected machine behavior because the ladder logic may not be executing under its original designed constraints. How to Disable the WN57 Warning

Understanding the FANUC WN57 Override Function Is Active Message If the machine was recently accessed remotely via

In many FANUC configurations, this function is tied directly to a system keep relay. The most common address used to control this function is . Go to SYSTEM -> PMC -> PMCPRM -> KEEPRL . Locate K906 and ensure bit 0 is set to 0 .

If the WN57 message appeared suddenly without manual intervention, it may indicate one of the following scenarios: Select [PMC SET] or [PMC PARAM]

Note: If K906.0 is already 0 and the message persists, check your machine builder's manual as they may have mapped the debug override to a different K-address. Why Did This Message Appear?