Gemel Txshs User Manual ★ Updated & Authentic

If you arm the alarm more than one minute after turning off the ignition, you must hold Button 1 for longer than one second. If the bike is left deactivated for over an hour, the system may shut down to save battery; in this case, cycle the ignition to wake it up. Deactivating the Motion Sensor

The turn indicators will flash three times, and the alarm tone will sound three times to confirm the motion sensor is off.

Release both buttons. The LED should now stay on. Press either Button 1 or Button 2 once. The LED should turn off. Gemel Txshs User Manual

Turn the ignition OFF . Test the remote by arming and disarming the bike. Maintenance: Battery Replacement The Gemel TXSHS uses a CR 2032 3V lithium battery.

Hi all, As I mentioned in one of my previous posts I was going to change the two small batteries in my BMW alarm box (Gemel TXSHS) Gemel TXSHS alarm operating advice needed - UKGSer If you arm the alarm more than one

Insert the new battery, ensuring it does not touch other electrical components. The LED should light up once the battery is in place.

Press to deactivate the system. The indicators will flash once to confirm. Synchronization Procedure Release both buttons

The TXSHS remote typically features two buttons and a status LED: Used to arm the system. Button 2 (Smooth): Used to disarm the system.