This task describes the process to get WinANT running.

Before you can get started, you need to have a computer with the DITA Open Toolkit and ANT successfully installed.

When you have DITA documents you want to publish, you can use WinANT to automate the processing of the output. Getting started with WinANT is a two step process which involves downloading and installing the application on your computer.

Download the WinANT installation program from the internet.
Install WinANT on your computer.

Hyt Tc580 Programming Software — New

If the cable isn't recognized, download the latest Prolific or FTDI drivers depending on your cable’s internal chip. Conclusion

The TC580 uses a standard 2-pin Hytera/Kenwood style connector. For the best results, use a cable with an FTDI chip , as these are "plug-and-play" and avoid the driver headaches associated with cheaper clones. hyt tc580 programming software new

Navigate to the "Channel" information folder. Here you can enter your RX/TX frequencies, CTCSS/DCS tones (to block out interference), and Power levels (High/Low). If the cable isn't recognized, download the latest

When searching for the software, look for or higher. Newer versions provide: If the cable isn't recognized

Explore the "Optional Features" to set up your side-key shortcuts, battery saver modes, and the emergency "Siren" function. Step D: Writing to the Radio