Liz: Ocean Wsg 32 Install ^new^

Liz: Ocean Wsg 32 Install ^new^

Ensure the brine tank and resin tank are standing perfectly upright.

Connect a 1/2-inch ID hose to the drain port on the control valve. Run this to a floor drain or standpipe.

Open the lowest faucet in the building to drain remaining water from the pipes. liz ocean wsg 32 install

Enter your local water hardness levels (measured in GPG) and the current time into the digital controller. The WSG 32 uses demand-initiated regeneration, so accurate hardness data is vital for salt efficiency. Maintenance Tips

Ensure there is a physical air gap between the end of the drain hose and the waste receptor to prevent back-siphonage. Ensure the brine tank and resin tank are

Pipe cutter, adjustable wrenches, Teflon tape, and soldering equipment (if using copper pipes).

💡 Check the brine tank monthly and keep it at least one-third full.💡 Sanitize: Use a water softener cleaner once every six months to remove iron and resin buildup.💡 Check Bridge: Occasionally break up any "salt bridges" (hard crusts) that form in the brine tank. Open the lowest faucet in the building to

It is highly recommended to install a three-valve bypass manifold. This allows you to service the unit without cutting off water to the entire house. Step 2: Positioning the WSG 32

Leave at least 6 inches of clearance around the unit for future maintenance. Step 1: Prepare the Plumbing

Shopping Cart (0 items)

Ensure the brine tank and resin tank are standing perfectly upright.

Connect a 1/2-inch ID hose to the drain port on the control valve. Run this to a floor drain or standpipe.

Open the lowest faucet in the building to drain remaining water from the pipes.

Enter your local water hardness levels (measured in GPG) and the current time into the digital controller. The WSG 32 uses demand-initiated regeneration, so accurate hardness data is vital for salt efficiency. Maintenance Tips

Ensure there is a physical air gap between the end of the drain hose and the waste receptor to prevent back-siphonage.

Pipe cutter, adjustable wrenches, Teflon tape, and soldering equipment (if using copper pipes).

💡 Check the brine tank monthly and keep it at least one-third full.💡 Sanitize: Use a water softener cleaner once every six months to remove iron and resin buildup.💡 Check Bridge: Occasionally break up any "salt bridges" (hard crusts) that form in the brine tank.

It is highly recommended to install a three-valve bypass manifold. This allows you to service the unit without cutting off water to the entire house. Step 2: Positioning the WSG 32

Leave at least 6 inches of clearance around the unit for future maintenance. Step 1: Prepare the Plumbing