Press the on the new remote. The siren will chirp to confirm. Turn the Ignition OFF to exit programming mode. Troubleshooting Common Issues

This is often caused by the ultrasonic sensors being set too high. Use the sensitivity adjustment screw on the side of the main module to turn it down.

According to the , the wiring harness generally follows a standard color code: Red: Constant +12V Battery. Black: Chassis Ground. Yellow: Ignition Switch (+12V when the key is turned). Green: Door Switch (Negative trigger). Violet: Siren Output. Orange: Parking Lights. Programming New Remotes

Understanding the WR 800 Alarm System: A Comprehensive Guide

Allows you to trigger the siren to locate your car in a crowded lot.