Sinotimer Mc101 Manual ((new)) Site

Correct wiring is critical for safe operation. Always disconnect power before making connections. Refer to the specific diagram on your unit's label for the most accurate pinouts.

Connect the AC power supply to Terminals 1 and 2 (typically 120V/240V L and N). Sensor Connection:

Hold the (or SET + <) keys for 3 seconds to enter the menu. Use the arrows to find the "Unit" parameter. Change the value from 000 (Celsius) to 001 (Fahrenheit). Hold the MODE key for 3 seconds to exit and save. Entering PID Auto-Tuning: sinotimer mc101 manual

For optimal control, you can trigger the function. Access the internal menu and locate the "AT" parameter.

To customize the controller for your specific application, use the panel keys (SET, <, ∨, ∧). Press the SET key briefly. Use the < key to select the digit you want to change. Use the ∨ and ∧ keys to adjust the value. Press SET again to save the new target temperature. Switching Units (°C to °F): Correct wiring is critical for safe operation

For models, use the internal relay contacts to switch your load.

0.3% measurement accuracy with a maximum resolution of 0.1°C for thermocouples and RTDs. Connect the AC power supply to Terminals 1

Four-digit dual LED display showing both the PV (Process Value) and SV (Set Value). Dimensions: Standard 48x48mm (1/16 DIN) panel mounting. Power Supply: Operates on AC 100-240V at 50/60Hz. Wiring and Installation Guide

For models, connect Terminal 5 (positive) and Terminal 4 (negative) to the control input of your Solid State Relay. Configuration and Setup

If using an SSR to control a high-current load, always attach a heat sink to prevent the relay from overheating.