Ts1162 Installation Manual Exclusive 2021 May 2026

: Fully protected against dust and immersion in water, making it suitable for wet or outdoor environments.

: Connects via the Challenger RS-485 LAN , supporting distances up to 1.5 km from the main controller.

The TS1162 connects directly to the Challenger system’s LAN. ts1162 installation manual exclusive

: Installation should be performed by trained security technicians. If electrical wiring for a power outlet (GPO) is required, you must use a qualified electrician .

: Three status LEDs provide clear system arming and area status information. Step 1: Pre-Installation Requirements : Fully protected against dust and immersion in

: If using an exit button, connect it to the Request to Exit input.

: Use high-quality twisted-pair cable for the RS-485 connection to ensure signal integrity over long distances (up to 1.5 km). Step 2: Mounting the Unit : Installation should be performed by trained security

: Log in to the Challenger Installer Menu (typically Menu + Installer Code + 19) to add and configure the new station.

Once hardware is installed, the RAS must be identified by the Challenger panel.

: Use the DIP switches or software configuration (depending on your specific panel version) to assign a unique address to the RAS.