V2000-c Rfid Access Control User Manual Upd Review

If you forget the Master Code or wish to clear all settings: Power off the device. Press and hold the # key while powering the device back on.

V2000-C RFID Access Control User Manual: A Comprehensive Guide

Before mounting, ensure the power is disconnected. The rear of the unit features a color-coded wiring harness. Description Positive Power Supply Black Negative Power Supply Blue Normally Open (Electronic Lock) Purple Common Terminal Orange Normally Closed (Magnetic Lock) Yellow Exit Button Input Pink Doorbell Interface 3. Programming Basics V2000-c Rfid Access Control User Manual

Press * + 999999 + # . (The indicator light will turn orange/flashing). Exit Programming Mode: Press * .

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring If you forget the Master Code or wish

Verify the input voltage is a steady 12V DC.

Enter programming mode, then press 0 + [New 6-digit Code] + # + [Repeat New Code] + # . 4. User Management Adding Users (Card or PIN) Enter Programming Mode. Press 1 . For Card: Swipe the RFID card. The rear of the unit features a color-coded wiring harness

Always change the default Master Code immediately after installation to prevent unauthorized access to your programming settings.

Enter a unique User ID (1-2500) + # + [4-6 digit PIN] + # . Press * to exit. Deleting Users Enter Programming Mode. Press 2 . By Card: Swipe the card you wish to delete. By ID: Enter the User ID + # . Press * to exit. 5. Advanced Settings Door Relay Time