Xmtg-2000 Temperature Controller Manual Pdf May 2026

Use the , ▲ , and ▼ keys to reach your desired temperature. Press SET again to save. Accessing the Parameter Menu

Displays the current measured temperature in red. SV (Set Value): Displays the target temperature in green. SET Key: Used to enter parameter menus and confirm changes. xmtg-2000 temperature controller manual pdf

Check if the "OUT" light is blinking. If it is, the controller is sending a signal, but your heater or SSR may be faulty. Use the , ▲ , and ▼ keys

Moves the cursor to the digit you wish to change for faster setting. 4. How to Program the XMTG-2000 SV (Set Value): Displays the target temperature in green

Used to increase or decrease values.

When looking at the rear of the XMTG-2000, the terminal numbering usually follows this standard layout (always verify with the diagram printed on your specific unit’s casing): Terminals 1 and 2 (Standard AC input). Relay/SSR Output: Terminals 3, 4, and 5. Sensor Input: Thermocouple: Terminals 8 (+) and 9 (-). RTD (Pt100): Terminals 7, 8, and 9. Alarm: Terminals 6 and 7 (depending on model variation). 3. Front Panel Controls