Zeus Z3 Digital Lock Manual Work File

: Place your finger on the sensor 4–8 times until the voice prompt confirms "successful." For RFID : Tap the card against the reader area once. Change System Language : Enter *39# and verify the admin. Press 1# for Chinese or 2# for English. 3. Physical "Manual Work": Installation & Maintenance

: Wake the system and enter 888# , then verify with your admin fingerprint or code. zeus z3 digital lock manual work

Enter the default admin code (typically 123456 ) followed by # . : Place your finger on the sensor 4–8

: A built-in USB Type-C port or 9V battery terminal allows for a "jump start" if the internal batteries die. 2. Manual Programming & Setup Guide : A built-in USB Type-C port or 9V

Before using the lock, you must configure the administrator and user settings. : Always perform these steps with the door open to avoid accidental lockouts. Initialize Administrator : Wake up the keypad by touching it.

: Most Zeus locks allow the latch length to be adjusted between 60mm (2-3/8") and 70mm (2-3/4") to fit standard door backsets.

: Uses a high-precision biometric sensor (often 360-degree accessible on the Zeus Z-3G ) that supports up to 50 unique prints.